Conduction Path Formation Characteristics of Solderable Polymer Composite Filled with Low-Melting-Point and High-Melting-Point Alloy Fillers

초록

In this study, low-melting-point alloy (LMPA) and high-melting-point alloy (HMPA) filler-filled solderable polymer composite (LH-SPC) system was proposed to enhance the mechanical and thermal properties of SPC with LMPA fillers. To identify the conduction path formation characteristics of LH-SPC according to the mixing ratio of LMPA and HMPA, four types of LH-SPC with different mixing ratios of LMPA and HMPA fillers (100:0, 80:20, 30:70, and 0:100) were formulated. Furthermore, a chip resistor interconnection test was conducted. The results indicated that LH-SPC with only HMPA did not form a conduction path because of the excessively cured polymer composite before melting HMPA. Meanwhile, LH-SPC with LMPA and HMPA fillers showed different conduction path formation mechanisms according to the mixing ratio of LMPA and HMPA fillers. In LH-SPC filled with lower HMPA content than LMPA, the conduction path was formed by the flow, coalescence, and wetting behaviors of molten LMPA containing solid-state HMPA at the melting range of the LMPA filler. On the other hand, in LH-SPC containing higher HMPA content than LMPA, the conduction path was formed by the wetting behavior of the molten HMPA at a lower temperature range than the melting temperature of HMPA because of the decreased melting temperature of HMPA owing to the chemical composition change of HMPA by the diffusion of Bi into HMPA.

키워드